Try to use your HP scanner again and see if it works now. Click Apply and OK to save the changes.If the Service status is already Running, click Stop to stop the service, then click Start to re-enable the service. In the popup pane, ensure the Startup type is set Automatic, and the Service status is Running.Scroll down and double click Windows Image Acquisition (WIA).On your keyboard, press the Windows logo key and R at the same time to invoke the Run box.So you should enable WIA service in your computer if your scanner stops working. Windows Image Acquisition (WIA) is a Microsoft model that allows graphics software to communicate with imaging hardware such as scanner and cameras. There is something else to try.įix 2: Enable Windows Image Acquisition (WIA) service and associated services If you’ve checked the above steps and your HP scanner still doesn’t work, don’t worry. In addition, if you’re using VPN in your computer, try disconnecting VPN from your computer and scanning again. While you’re using a network scanner, ensure your computer has a good Internet connection, and your scanner connects to your computer under the Internet. If you’re using a USB scanner, check the USB ports and USB cables to ensure it works properly. Then you should check the connection issue. To use your scanner, you need to make sure that your scanner is powered on in the first place. Install any new software, if prompted.The screenshots below come from Windows 10, and fixes apply to Windows 7 and Windows 8.1. USB connection: Connect the cable to the USB port on the rear of the printer and to a port on the Mac. At the printer port, the green light should be steady and the orange
Wired (Ethernet) network connection: Connect the network cable to the printer Ethernet port and to an available port on the router or access point. The blue bar stops flashing when the connection completes.
Within two minutes, press and hold the WPS button on the router until the connection process begins. Wi-Fi connection for HP DeskJet 60, ENVY 60, and Tango printers: Press and hold the Wi-Fi button and the Power button on the back of the printer for five seconds until the blue bar flashes. The printer wireless light stops flashing Within two minutes, press and hold the WPS (Wi-Fi Protected Setup) button on the router until the connection process begins. Wi-Fi connection for most printers without a touchscreen control panel: Press and hold the Wireless button for five seconds or until the wireless light starts to flash. Wi-Fi connection for printers with a touchscreen control panel: Open the Setup, Network, or Wireless settings menu, select Wireless Setup Wizard, and then follow the instructions to select the network name and enter the password. Connect the printer to the same network that the Mac is connected to, or use a direct USB connection.
0 kommentar(er)
